Hello All,


On this short video I am showing the way that the Bedini's Lockridge Device replication had brushes adapted from a Delco-Remy Starter Motor.
As the way I'm showing the possible ways it could have been done.

MERRY CHRISTMAS TO ALL!!

Ufopolitics

Good video thanks.

Quote from: Ufopolitics on Dec 22, 2024, 08:24 PMRelated to Bedini's explanation about the Lockridge Device replication Components that He showed:

1- We have a capacitor based on two 30 feet copper sheets wrapped with an insulator (Butcher Wax Paper) sandwiched in between, which also wraps around the Dynamo Steel Body.
2- Plus a Trifilar, fine wire TRIPLE INDUCTOR CIRCUIT, which delivers Three Pairs of Terminals (six wires) of which we do not know each Inductor Individual Resistance and Inductance values...and that these 3 Inductor Component also wraps around the Steel Body of the Dynamo as it "Inductor Core"

UFO- The resistance on the tri coil needs to be matched to what ever it is connected to otherwise it slows the motor down. problem i am having is getting enough amperage through it to light the lights on the light circuit. For me it trial and error method.

To test the tri coil it need to be on the case or another generator case. Also if on the actual machine it self it has to be turned a certain way to get it to work freely and not interfere with the transformer action or the running of the machine itself.

I havent done anything with the capacitor at all yet. Another night mare.

UFO I have the gen case set up for cw rotation. How do you think I should proceed with this next? What should I be looking for?

Quote from: hiwater on Dec 25, 2024, 01:06 PMUFO- The resistance on the tri coil needs to be matched to what ever it is connected to otherwise it slows the motor down. problem i am having is getting enough amperage through it to light the lights on the light circuit. For me it trial and error method.

Hello Hiwater,

Yes, the Tri coil Resistance has to be matched, definitively. However, this is not that simple, this is a 3 Coil System and the way I think it works, is based on a Main Coil (Primary) of which is the one where should be matched to the Dynamo (Generator) circuit, where the Capacitor is connected as well.
The other two coils I believe are the Secondaries that feed Motor Brushes as Stators.

Quote from: hiwater on Dec 25, 2024, 01:06 PMTo test the tri coil it need to be on the case or another generator case. Also if on the actual machine it self it has to be turned a certain way to get it to work freely and not interfere with the transformer action or the running of the machine itself.

According to the way the Tri-Coil Field is, versus the Dynamo Field(s) is exactly at 90 degrees, and IMHO, it should not have any interference.

Quote from: hiwater on Dec 25, 2024, 01:06 PMI havent done anything with the capacitor at all yet. Another night mare.

The Capacitor -again, I believe- it does not need to be made out of copper, but also of Aluminum wrap paper, the thicker one, not the cheap one, which is very thin, that is NOT good!!

Cheers

Ufopolitics