Discussion about the Lockridge Device

[hiwater]

Here I am also showing BOTH JUMPERS, and like I wrote before, they need to be of the THICKEST WIRE you could get...in order to FORCE CURRENTS through the "LESS RESISTANCE PATH" and so AWAY from Shorting circuit with other brush next to it...

I did try something similar to what you have shown. Brush placement was a little different. I was driving the generator withe a drive motor. 

It pulled so much power from the fuse panel that it burned up the fuse panel socket and fuse. I was trying to get the amp meter on to check the amperage. Burned out before I got it connected. Should have had it on before I started the test.

So those little generators will put out plenty to sustain itself just got to figure out how.

[hiwater]

Now, can you try this setup on your end

UFO - I do have a stock GM that have the slots cut for the extra brushes and slots cut for moving the 4 pole shoes. So soon as I get the right time I will surely check this out. It pretty much done already. Just need to do some adjusting.

[Ufopolitics]

JUST A FEW DEGREES VARIATION (CCW) OF BOTH BRUSH PLANES TO MAKE DEVICE TO OPERATE AT CCW ROTATION

Hello to All,

Please review below image carefully:

Ok, on this image, which is IDENTICAL to my latest image posted, EXCEPT that I had TURNED COUNTERCLOCKWISE BOTH BRUSHES PLANES (Dynamo and Motor) just a few degrees, BUT ENOUGH TO PASS BOTH NORMAL PLANES, ALSO BY A FEW DEGREES.

And by doing that, I am REVERSING THE MAIN TORSION FIELD BETWEEN ARMATURE AND STATORS, resulting in a reversal of Rotation on which Device operates now...
And this setup is more likely to the way my FORD Dynamo works, again, looking from the Brushes End Cap.

I could have also just MOVED THE MOTOR BRUSHES PLANE, leaving the Dynamo Brushes Plane in place...BUT, by doing that I would be WIDENING THE SHORT CIRCUIT ANGLE between Positive-Negative Brushes Plane.

And I do NOT want to do that...but TO KEEP THE SHORT CIRCUIT ANGLES (YELLOW BACKGROUND) AS NARROW AS POSSIBLE!!

Now, this is the BASIC PRINCIPLE that I believe Lockridge Device works...as we could ADD TWO MORE STATORS to AMPLIFY INDUCTION, as to WIDEN BOTH EXISTING STATORS MAGNETIC FIELD.

So, if I were to add TWO MORE STATORS, I would add a NORTH on TOP, as a SOUTH on LOWER AREA, leaving the Main Stators as they are now.

This Image was done ONLY to demonstrate that by turning a few degrees BASICALLY THE MOTOR BRUSH PLANE, we will have REVERSED THE MOTOR ROTATION TO CCW.
BUT, according to this NEW ROTATION DIRECTION, the DYNAMO BRUSH PLANE IS ON THE HIGHEST PLANE OF MAGNETIC MAX DISTORTION, so, the Dynamo Brushes are going to SPARK GALORE...but that could be simply repaired by DISPLACING JUST THE DYNAMO PLANE BRUSHES to the OPPOSITE ANGLE TO MAX DISTORTION, leaving the Motor Brush Plane at the SAME PLACE is now.

Or what it would like:

Regards

Ufopolitics