Discussion about the Lockridge Device

[Ufopolitics]

Hello UFO,
              Here is a link to a youtube video of John Bedini explaining the function of the Lockridge device. It was , self runner, maybe some similar functions in Figuera device.

Hello to All,

Upon request, here is the Topic dedicated to the discussion of the Lockridge Device.

Thanks

Ufopolitics

[Greg GKP]

Hello UFO,
                I understand the Lockridge device is a different design. The thing that stands out in the Bedini video is that when the brushes wore out and the user replaced them with off the shelf brushes it would no longer work.  Bedini explained that  the design of the brush was the key to make the device work.  The off the shelf brush needed to be modified , filed down to make it sit properly on the commutator.

[hiwater]

Greg . For better effeciency the main brushes were narrowed down to fit the comm bars. Also if their were blank bars on the commutator the collapse goes back in to the other windings. And would burn up the commutator very quickly.

So my thought is their were two half brushes on one comm bar with insulation between them. Another aspect of the motor was if it wasnt pulsed at the main brushes. Their was another commutator added for pulsing to get the tri coil to work. In that case the brush was to be one commbar wide. If and when it wore down and became wider it wouldnt pulse the tri coil. Because it would connect both sides of the added commutator and wouldnt have the pulsed DC effect.

[Ufopolitics]

Hello,

IMHO, I do NOT believe that just by replacing brushes on a given device, whether by "off the shelf" or customized brushes, will prevent from an Overunity Machine to stop, radically working as it was before...

As it could drop in performance, because the angles (if that was the case) were altered to make new brushes contact...

But keep in mind that brushes are set within a Metal HOUSING, where a spring pushes them against commutator bars...it is normal that brushes wear out, as they are "consumables", however, not their Housings, nor their springs, unless spring's metal is "fatigued" because of prolonged heat...then needs replacement.

So, unless whoever was working on replacing the brushes was a RETARDED Moron, as He replaced EVERYTHING, including Housing plus seating plates, NOT considering brush-width or angles ...it should not be the cause.

Thks

Ufopolitics

[Greg GKP]

Hello, here is a link that will take you to more information about the Lockridge Device.


www.rexresearch.com · LockridgeDevice · LockridgeDeviceThe Lockridge Device - Rex Research



When you land on this page click on another link at the upper part of the page that has www.plasmashop as part of the link, a pdf will open . The link sits above the cutaway motor.

Hope this helps some who may want to try and replicate it.