Discussion about the Lockridge Device

[Ufopolitics]

TESTING CURRENTS ALIGNMENT BETWEEN BOTH SYSTEMS (MOTOR-GENERATOR)

Hello Hiwater,

Ok, this is the other test that we will need AFTER you complete the First Tests (Output Power):

We want to be able to:

1- While you have Generator LOADED, with Dynamo running with external motor at the lowest speed that you previously tested for Output...THEN, start adding MINIMAL Voltage FIRST to Motor Brushes from an external Regulated Power Supply, but using the Motor Brushes Electrical Polarization specified on the Diagram.

And here, please read carefully: you must start FIRST with a VERY LOW VOLTAGE supplying Motor Brushes, like 2 or 3 volts...then READ the Amperage that shows on your MOTOR Power Supply.

So, depending that the Amperage does not go too high on your source, then dial a bit more voltage...and so on, until you get to Operating Factory Voltage (12V?)

And things you are going to be looking for on this test, while adding external power to motor brushes:

1- Watch the Dynamo Speed...if it DECREASES or INCREASES when you start the minimal voltage (2 to 3 Volts) to Motor Brushes.
2- Watch your Generator Load Output...if it INCREASES on Output Power or it DECREASES.

You may get some sparking between brushes of opposite electrical sign,(Motor-Generator) the minute you start adding MINIMAL power to Motor Brushes. NOW, if sparking increases too much as you increase power to Motor brushes, please STOP TEST!!

This Test is the MOST IMPORTANT TEST, as it will tell us if we really have Both Currents ALIGNED on the same direction for real.

If we DO, then 1 and 2 would show an INCREASE on BOTH PARAMETERS, Speed and Generated Output.

@hiwater, PLEASE, DO NOT "jump the gun" and do this test BEFORE you do ALL prior Tests!!...You need to know FIRST the Capacity of Output Power we are dealing with here versus the RPM's!!

Thanks!!

Ufopolitics

[hiwater]

UFO Lots to digest here. I printed off the procedures so I can study them before I start the tests. Im sure i will have some questions. 

Too much going on now thru the holidays . When I start something I like to keep focused on it. So after the holidays woild be the best time to do this. OK. thanks Hiwater.

[Ufopolitics]

@hiwater and All interested on building-testing my suggested setup for the Lockridge Device,

Ok, so, after going over and over about whenever we change Rotation Direction on the device we are going to setup for Test...I came up with the conclusion that:

We will also need to Swap (Switch Places) between the Brushes Planes of Motor and the Generator.

So, previously I have posted the image below:

And as you can see BOTH BRUSHES PLANES are on the identical positioning (relating to which one is first as which one is second, NOT referring to "exact angles" here) as on the CCW ROTATION (Image below):

And these BRUSH PLANES SETTINGS ARE NOT CORRECT for the CW ROTATION!

Why?...Because depending on the Rotation Direction, a "General Rule" is that the Generating Brush Plane MUST BE SET PRIOR (BEFORE) to the MOTOR BRUSHES PLANE, ACCORDING TO THE ROTATION DIRECTION.

This way the Motor INPUT of Currents into the Armature will not interfere with the Generating Currents that we will collect.

So, this is "not a big deal" when testing this setup, as all you need to do, is to swap the Input to Motor with the Generating Brushes as your Motor Brushes Plane would be now the Generating side brush plane.

Like I have done on image below:

However, there is more to this settings that will allow us to play with this positioning for best performance of the Device.

Regards

Ufopolitics