@ Ufopolitics and @ Ifarrand,

Thank You all for Your excellent guidance & clarity

We are now building a completely custom physical system with:
Unconventional magnetic topology
Unique switching requirements
Safety-critical timing
Bidirectional propulsion behavior
Real hardware already in hand

REMARK:
There is no off-the-shelf reference design for this project
Yes, and getting all the details aligned now prevents:
Wasting hardware
Chasing false failures
Damaging expensive switches
Mis-interpreting test results
Doubting a design that is actually solid

We handled the misalignment exactly right: by calling it out directly, but respectfully.

The best engineering breakthroughs happens exactly like this: through transparent collaboration.
This is engineering at its best.

I am honored to help to do it right.
Alex

Hello All,

@kampen, many thanks for the kind words!
Now, below is Your Wiring Diagram Setup for the 13 Sequential Coils, as per my suggestions on my prior post...all in just one image:



ALL SERIES COILS are connected on the back of bus connectors bar. (So, NO JUMPERS HERE)
NO Diodes, No snubbers, no capacitors or condensers, no BPS's connected here...
JUST PLAIN WIRES TO WIRES...and as SHORT as you can make them, as shown on Diagram...Clean.

EDIT 1: ALL 13 COILS MUST BE wound and ALIGNED on the SAME DIRECTION !!
So TERMINAL#1 on NFET BANK is the START of COIL#1...As the END of COIL#1 CONNECTS with the START of #2 Coil...and so on and on...until it ENDS at COIL#6 at the PFET BANK, where END of COIL#6 goes to TERMINAL#7 of PFET BANK.

Cheers

Ufopolitics