Hello to All,

After I complete ALL my testing with ALL Boards, and show that they will work as expected, on the DUAL MODULE CLOSED SYSTEM:

I WILL GIVE AWAY FOR FREE, A FULL SET OF THESE BOARDS, TO ANY BUILDER HERE THAT SHOWS US A FULL BUILD, BASED ON THE DUAL CLOSED MODULE SYSTEM, AS I HAVE DISCLOSED BEFORE.

And this Builder MUST compromise to be showing his/hers results on Videos here, on this Open Source Forum.

This way we will start seeing the results from different sources.

The Spec's of ALL Windings are on my Builder's Topic here:

Ufopolitics Figuera's New Method, for Builder's details in replicating ONLY! - Page 7 (overunitymachines.com)

So, it does NOT need to be a Quad Module Build, but only a Dual (Two) Modules Set.

The only thing that would change now, are that cores are square and laminated, instead of round and solid steel, like on my previous setup.

I will ship the boards for FREE to any part of the World, where this Builder is located.

Regards

Ufopolitics

Hello to All,

I already received all the Electronic Drivers from Kampen.

All arrived in perfect conditions.

The Overlapped Version 2, which is the more complicated one, came without its attaching harnesses, as it was not allowed for security reasons to have harnesses installed.

So, the Version 1 is the easier one to connect, as it came with its harness, but off, but already made to go on male-female pin connectors, so, all needs to be done is to plug them in.

Version 2 have two BUS Rails on the Logic Boards, one for each FET Bank (P & N FET) while V1 has only one BUS that splits to the FET Banks.
The V2 Banks are not specified on boards, so I have to go over with Kamper about a clear connection there.

Meaning that first, I am going to test only the V1 with the Single Module I have.

In the meantime, I am gathering all other materials for the closed build.

I already have all 1 1/2 inches, steel laminated strips, 10 ft long, see images below, there are about 30 of them...


I already spray-soak them with silicone oil, to prevent surface rust, then wrapped them together.

but they would be on moisture control environment, never exposed to outside weather.

Regards

Ufopolitics

Hi Mr. UFO,

what is the thickness of the stripes?

Quote from: Art Z. on Jul 11, 2024, 11:42 PMHi Mr. UFO,

what is the thickness of the stripes?

22 gauge Art,
Sorry, I forgot to mention thickness.

Ufopolitics

@ Ufopolitics,

Dear, please check Your email sent You the wiring diagram and BOM files.
If you did no receive these, let me know.

Greetings, Alex