Demo- Neutralizing the Gate.

Ufopolitics · Mar 28, 2024, 04:49 PM

Hello,

Muammer Yildiz...was the inventor from Turkey, I was talking about...on my previous post.

On video go to minute 3:00, That is when He loosens the lever locking mechanisms then just "Taps" Drum lever, (IMO it should be like a "Fork" type at the actuator, connected to shaft, that allows to secure it back while motor is running) with a small hammer, to fall on the right position (within the magnetic fields of both Stators) and motor starts...

Then he secures again the lever, on the "ON" Position, while motor is running...in order that drum stays on place.

Regards

Ufopolitics

floodrod · Mar 28, 2024, 06:05 PM

My model uses the blotch wall of 1 solid magnet to make the neutral zone. There is no need to separate the inner magnet and make an air gap.

I think it can be done optimally by using a setup like UFO posted but with 1 solid magnet in the middle.

Ufopolitics · Mar 28, 2024, 06:44 PM

Quote from: floodrod on Mar 28, 2024, 06:05 PMMy model uses the blotch wall of 1 solid magnet to make the neutral zone. There is no need to separate the inner magnet and make an air gap.

I think it can be done optimally by using a setup like UFO posted but with 1 solid magnet in the middle.

Hello Floodrod,

And many thanks for presenting your demo video!

Yes, you could use a full center magnet, however, not fully solid, because you need to have a hole, so you could run the drum shaft...right?

In order for this motor to work smooth and not to get stock, the Inner and Outer Stators need to be around the same strength or balanced out.

That is the reason why I used cubes or arcs of more or less the same force.

If either outer or inner stator magnets are stronger, then steel bolts or studs will tend to lock on the stronger magnetic force.

That is just my opinion though.

Thanks

Ufopolitics

RhineX · Mar 28, 2024, 06:59 PM

Hello everyone, I would like to ask why Beletskiy's device is not functioning properly? I think it should be able to run normally... $:-\$

floodrod · Mar 28, 2024, 07:26 PM

Quote from: RhineX on Mar 28, 2024, 06:59 PMHello everyone, I would like to ask why Beletskiy's device is not functioning properly? I think it should be able to run normally... $:-\$

From my experiments, you can't just place magnets around it. Outside stator magnets just realign the bolt's field and stick.

IMO- Cifta's design is worth considering. The magnetized bolts will attract to steel and neutralize at TDC.