Demo- Neutralizing the Gate.

[Ufopolitics]

Hello everyone, I would like to ask why Beletskiy's device is not functioning properly? I think it should be able to run normally...

Thanks Rhine X,

Same principle as shown here...

First, I see too big of a gap between Rotor and Outer Stator.

Second, the Outer Stator must "wrap" around Rotor, and there is too wide space on the "Neutral Zone" between both outer stators.

If you look at it closely, it only have a small center area of interaction from outer stators and rotor on both sides.

In my opinion, it is not well balanced plus it needs wrapping outer stators, same way a regular motor is designed.

Regards

Ufopolitics

[Ufopolitics]

Hello All,

Here is a Graphic Solution to Beletskiy's Device...like "they say"...one image is worth 1000 words.

On the LEFT is Beletskiy's Device, and I have specified all errors on its design, with distance GAP brackets and magenta circles.

The Gaps are too wide EVERYWHERE, so Magnetic Interactions are VERY weak.

Magenta Circle shows the ONLY area of REAL and strongest Magnetic Interaction.

On the RIGHT IMAGE is a Running Device.

Now, he has too many "Steel Bolts" at ROTOR, and that will result on a motor that runs very slow, but have a lot of Torque...

The LESSER "Bolts" you have, the faster motor will run, but have lesser torque.

The "Steel Bolts" are equal to Number of Coils and Steel Poles Faces, on a Brushed DC Motor Armature...

Same, identical principles of Electric Motors, basically the Brushed Type.

Regards

Ufopolitics

[Ufopolitics]

Hello to All,

Here is another short-video that Stefan (from OU) received a while back and uploaded to his YT Channel...from a Russian Inventor-Developer.

Point is that it Starts and Stops based on the same principle of sliding one of the components on and off the track, in this case he is bringing into centered position just ONE of the TWO Outer Stators:

Regards

Ufopolitics

[Ufopolitics]

Hello to All,

Well, I guess everyone is building this Magnet Motor...or have given up on this idea...

I will tell you "Up front" that it will work, However, I have found some small error (flaw) on its design...but it could be corrected and be even greater.

And that is the fact that both Stator's Field, by being facing each other's, or both Stator's B-Fields being parallel, this creates a tendency that outer stators can also influence magnetically the "bolts" heads and as such, it will not spin.

So, in order to define which field influences the Steel Rotor component's, we need to set the bolt's end, closer to the inner stator, as to use a longer bolt...that way Outer Stator will only react with the bolt's head.

However, this setup creates a huge air gap between inner-outer stator field's...rendering a weaker rotating motor, if, it rotates at all.

I am developing a much better way to overcome this flaw...however, I will make a separate Topic on Magnet Motors Board, related to this build...As I do not want to keep clogging this thread @floodrod ...
As I figure he will have a self-runner to show us all here, pretty soon...

Regards

Ufopolitics

[floodrod]

We know from my video it will attract to steel. And it will release steel.