Ufopolitics Figuera's Linear Pump Discussion/Questions

[citfta]

I already posted on my topic info regarding "reactive power". When voltage collapse excessive curent start to flow demanding even more current from source (generator coil) and system will shut down or overheat ! It is quite clear that in this point the voltage must be sustained, not the current. Solution is to inject reactive power with voltage leading back into generating coils using a shunt reactor (almost ordinary oscillator) if you look at the picture showing such shunt reactor on the page with link provided.

The part above that I just copied is total nonsense.  You keep bringing up stuff that has nothing to do with what UFO and Kampen are working on.  Please either find another hobby or spend the time to actually learn about electronics before trying to tell others they don't know they are doing.  You've already admitted electronics is not your strong point so please stop trying to tell others they are wrong.  I suspect you have gotten your education from YouTube videos.  That is the worst possible way to learn anything.  If you are serious about wanting to learn electronics then I suggest you find some real books and start studying.  A real good place to start is with a ARRL Handbook.  That is a book for amateur radio operators to use to learn electronics.  You can find older copies on eBay pretty cheap.  Even one 10 years old will have all the basics you need to learn to really understand electronics.

Respectfully,
Carroll

[citfta]

  "Once that we close the circuit at output by adding a load, there is a Secondary Magnetic Field generated instantly, and that field is completely Static/Fixed to steel core and opposed (Lenz) -in polarity- to the exciting/induced field, creating a strong attraction, this reaction will generate a slow down tendency on any moving field, no matter if it is physical or virtual."

HI Ufo,  I am sorry but I have to disagree with a small part of your statement I copied above.  I highlighted in red the part I disagree with.  As you correctly stated in a IC engine powered generator the load will decrease the engine speed if the governor did not adjust for the extra load.  This of course as you said is because of increased Lenz effect causing added load to the engine.  

However I don't know of any mechanism that would cause a virtual rotating field to slow down with increased load.  The speed of the rotating field or frequency is only determined by the drive mechanism.  In the case of your new design the brushes will be rotating at a speed determined by the motor driving the brushes.  That is all that will determine the speed of the rotating field.  The brushes are NOT going to slow down because of an increase in load.

The only thing that I think will happen is that as you draw more current from the secondary the current in the primary will go up.  But the speed of the brushes will remain the same.

I have read your comments about raising the frequency to increase the output.  And that is true up to a point.  If you recall the video that I posted somewhere on this forum I showed that if you go too high in frequency the output will drop off because of the inductive reactance.

Respectfully, your friend,
Carroll