FIGUERA'S AETHER MAGNETIC FIELDS LINEAR PUMP, REVIVED

[diplomiti2011]

Hello UFO!
It's Dmitry! Im from Transdnistria! My dream is to construct Free Energy Power Plant for my state for 100 Mega Watt. And I want to develop Fuelles Unit from 10W - to 100 MW. And I know Solid Works and a little bit Maxwell 2D.
My wish is fueles unit without moving part. And i have programm for draw shemes - Splan 7.0

And I Want to ask You about your sucsess in constructing Free energy Generator Figuera, it's work??? And I want to construct Generator Figuera in Your cloused group!
I have the opportunity to order a core for your plan of Generator Figuera made of electrical steel in any form. This core are made from electrical cteel and cut with a laser on the ЗАО Electromash.
I can add a sketch for one sheet of all core.
Here is a sketch for one sheet.


I can also make a frame for the coils printed on a 3D printer and placed on the core.

And I need to know the configuration for the all coils.

Regard.
Dmitry.

[diplomiti2011]

Here is a sketch in mm for core made from slectrical steel. 0.5 mm width.


Here is a several core made from several sheets. 

[Ufopolitics]

Hello Diplomiti2011 and Welcome to Overunity Machines!!

I already got you on the Builder's Group.

But hold on, easy, slow down!!...I will soon show my new configuration for the Exciter Coils and Secondaries when I finish winding all coils.

Thanks

Ufopolitics

[Ufopolitics]

Hello to All,

Here is an update video about my build:

Like I have mentioned on video...I am not that happy with the way this new design has turned out SO FAR, basically related to voltage drop...
However, I have not fully tested a completed secondary set of eight coils.

But, related to all the tests I have done so far, with different coils, then comparing to the other design on Ring Sequential Coils, it is not completely satisfactory.

And this is the way this development works...some setups work superb from the beginning, the first test...and others simply do not.

There are major setbacks on its design, like room for secondary(ies), compactness, and basically the Field it develops on the center sequence coils, due to its higher resistance it is not as great as previous design, so, induction is weaker there.

Induction is greater between the two fields (F1 & F2) and end sequential coils, like I have mentioned on video.

I am making a second coil of 18 gauge to run a test to upload it, probably by the start of next week.

Regards

Ufopolitics

[Ufopolitics]

Hello everyone,

Ok, so after hours of running a full check up on the whole setup...I finally found the specific issue I was having with one of the sequential coils groups, (Point 1, 2, 3, 4) that I had the magenta channel connected to point 1. And it was that the peak on the scope sinewave, was much lower than other group [Point 8].

And here is a short video that I highly recommend to all builder's making or having a commutator based rotary switch driver, to make this test, before even starting to connect to your generator.

So, this is the main reason the previous tests I did on this new design were terrible!!

Regards

Ufopolitics