FIGUERA'S AETHER MAGNETIC FIELDS LINEAR PUMP, REVIVED

[Ufopolitics]

Hello All,

This Post is just a CONTINUATION OF THIS NEW ALTERNATED COMMUTATION METHOD, with previous Transitions suppressed, where Q1 & Q2 were connected in PARALLEL is just "History"...

As here I will be showing just THREE STEPS GRAPHICALLY:

• Q1 ON, Q3 ON, Q2 OFF
• DEAD TIME, just Q3 ON
• Q1 OFF, Q3 ON, Q2 ON

These Steps will keep repeating over and over...for the FOUR CYCLES of completion of ONE REVOLUTION...

STEP1: Q1 ON

According to the positioning of the Q1 RED Brush (down at approx 5:00 O'Clock), it would be closing circuit of Q1, turning ON Q1 (red coil on LEFT)
Now, Q2 is also at another 'Q1' RED Contact at 180 degrees, However, NOTHING WOULD HAPPEN as Q2 Positive will NOT find a way to close circuit...
Therefore, Q2 IS OFF here (GREY LEFT COIL on image).
Q3 is ON (GREEN CENTER COIL)

STEP 2: DEAD TIME

So, BRUSHES following the Rotation 'R' Arrow (CW)...
BOTH END COILS Q1 & Q2 ARE OFF HERE.
ONLY Q3 Coil is ON (Green Coil)

STEP 3: Q2 ON

Following Rotation Sense here...

Q2 BRUSH has made contact with Q2 Element at Commutator, therefore CLOSING CIRCUIT of Q2:
Q2 IS ON (BLUE COIL AT RIGHT)
Q3 IS ON (GREEN CENTER COIL )
Q1 is making FULL CONTACT witha Q2 Element, however, NOTHING HAPPENS HERE, THEREFORE:
Q1 IS OFF (GREY COIL LEFT) 

And so these Steps repeat over and over...Next, Q1 & Q2 would enter another Dead Time...according to Rotation "R".

Q3 GREEN CENTER COIL would be ON at ALL TIMES, this Center Coil will keep Field 'alive', without the need to OVERLAP any steps.

I believe this is a MUCH CLEANER SEQUENCING METHOD, as here we should not have ANY SPIKES, as ANY Current rises...meaning that Field will keep same Strength, regulated by ALL Three PSU's.

As, since we are powering independently ALL THREE Coils, then Balancing of Magnetic Field would be much easier.

Regards All

Ufopolitics