FIGUERA'S AETHER MAGNETIC FIELDS LINEAR PUMP, REVIVED

[Ufopolitics]

Hello dear friend @kampen ,

Please excuse my frustrations as my lack of patience about all this errors.
Maybe because I know all these spec's by default are always present on my mind, I wrongfully expect that everyone should also have this methods as spec's based on the graphics, and all kind of explanations that I have exposed here many times... should be the same for all as I do.

I know you -and your team- have been the ONLY ONES on this Forum, that has always FULLY cooperated with me since the beginning of this Topic, and I DO appreciate that!

Therefore, I owe you an apology!

Going back on this Three Coils build:

The Q Coils that you have are done with 28 ga, correct?
Because that is what we calculated previously, as I reviewed all our past posts since the proposal of the 5 Coils setup.(pages 176-177)

On your previous post on page 176: https://overunitymachines.com/index.php?msg=3267
There you expose your build spec's related to Q & FC Coils.

On the Feedback Coils FC's I calculated that -for this Low V application at Input- it could be done with just 23 gauge, just to obtain around 14V with higher amps, in order to Supply Power to feedback the system, without any downgrade or buck converters.(just what is needed)

On the Main Secondary, since you are going to have such reduced space of only three single coils.
Then you could use 18 ga, which will give you more turns that 16 ga would.

But definitively, yes, the Feedback Coils are meant to use coarser grade wire, similar to main secondary.

Again, the FC's Geometry must be as narrow (length across steel core) as possible.
As, since FC's are wound from the steel core itself, as nothing is limiting their Height, it will give you enough room so it will take also a coarser wire than previously discussed 23 ga.

You could prepare two sets of FC's Coils also with 18 ga, in order to test their difference in output, versus your existing ones with 23 ga.

Regards

Ufopolitics