FIGUERA'S AETHER MAGNETIC FIELDS LINEAR PUMP, REVIVED

[Ufopolitics]

Hello All,

Well, here I have made a CLEANER WIRING DIAGRAM on the SAME CIRCUIT of the 16 Elements Commutator and the THREE COILS Minimalist setup:

(You can Right Click on Image and open it on a New Tab or Window...this way it will display on its full size (1900 X 1033)

I only hope that now it would be better understood, since I used the OLD Wiring Convention of curves around the "no connection" with crossed wirings.

I have also noted the 'S' & 'E' (Start and End) of each Coil plus its identical Electrical connections related to (+) & (-)

EDIT ONE: Please note that I have INVERTED Q3 COIL & TERMINALS POSITIONING on this Diagram, (for sake of understanding wiring properly) HOWEVER,  WHAT MATTERS HERE IS ESSENTIALLY "THE MAGNETIC POLARITY TO BE AN ATTRACT CHAIN!!".
And that is to ALWAYS KEEP AN ATTRACTION CHAIN between ALL Three Coils  (Q1, Q3, Q2), or N/S>N/S>N/S
So, it shows here the SAME ELECTRIC POLARITY (for ALL Three Coils), that is: End is ALWAYS POSITIVE, as START IS ALWAYS NEGATIVE !

And am sorry, but I can NOT make it any cleaner and simpler than this diagram shown above!!...

Regards

Ufopolitics

[Ufopolitics]

Hello All,

Ok, so, in order to make this Three Coils with the 16 Elements Commutator DRIVER much more 'understandable'...I have another way to look at it.

When we look at my 16 elements commutator, and the way I am wiring it INTERNALLY, we have this Diagram:

So, if we look at this Diagram in detail, we notice that I have TWO COMPLETELY INDEPENDENT CIRCUITS HERE:

• The Q1 RED CIRCUIT, which joints TWO ELEMENTS TOGETHER ALTERNATIVELY.
• The Q2 BLUE CIRCUIT, which joints TWO ELEMENTS TOGETHER ALTERNATIVELY.

Then EACH CIRCUIT DERIVES INTO JUST TWO TERMINALS:

• Q1 RED CIRCUIT SINGLE OUTPUT TERMINAL.
• Q2 BLUE CIRCUIT SINGLE OUTPUT TERMINAL.

NOW, as we can see on Diagram above, we actually have:

• FOUR Q1 (RED) DOUBLE CONTACTS.
• FOUR Q2 (BLUE) DOUBLE CONTACTS.

THEN WE CAN CONCLUDE...THAT WE HAVE CONVERTED A SIXTEEN (16) ELEMENTS COMMUTATOR TO JUST AN EIGHT [8] ELEMENTS COMMUTATOR.
(AS IT IS CLEARLY UNDERSTOOD THAT THIS SETUP COULD WORK PERFECTLY FINE WITH AN 8 ELEMENTS COMMUTATOR)

Therefore, above I have made an EIGHT ELEMENTS COMMUTATOR, in order to SIMPLIFY the way we look at the 16 Elements, which seems 'too complex', due to ALL the Jumpers between TWO ADJACENT ELEMENTS.

Still we have a TOTAL of EIGHT TRANSITIONS between each Q1-Q2 TRANSFER.

Again, I have done this 8 Elements Commutator to merely SIMPLIFY my setup, in order that it could be better understood.

Regards to All

Ufopolitics

[Ufopolitics]

Hello to All,

About these future tests...
I feel we could find some 'magic' into them...I really do!
And I center my thoughts about its CENTER COIL (Q3) we can make it, be 'induced' by the Q1 & Q2 Interactions...
By simply adding a cross diode between its terminals...and having it feed itself!
As long as Magnetic Polarization takes place in the previously described Attraction Chain...
It would be wonderful, wouldn't it?
That Q3 would be a self feed coil?
Just based on the interactions between Q1 & Q2?

Think about it...

Regards

Ufopolitics