FIGUERA'S AETHER MAGNETIC FIELDS LINEAR PUMP, REVIVED

[Ufopolitics]

Hello All,

I already started on the Copper Cylinder cutting & alignment (on borders) and balancing:

I plan to cut out first the Two Commutator Rings together as one piece, mark all segments/angles, tabs space and just cut -and bend- the tabs at both ends only.

Then I will run an interior 'cleaning and rectifying' -for both commutators as one piece- with very fine inner blades (at Lathe) running inside cylinder (future area of commutation where brushes will ride)

I plan to just mark all segmenting cuts for the two commutators as they are one piece, so there will be no error on spacing cuts for both at the same time.

Then cut in half and do each commutator separately, because once I insert the polycarbonate rings and bent the other tabs...the polycarbonate rings can not be removed.

Then drilling and bolting them up (both commutators separately) ...the passing bolts will secure each segment in place...then cut segments all the way through (final step)

And to go over each air gap, smoothing edges, running the V File....and done!

The continuos slip rings are a 'piece of cake'...simple to make, as they would not need as many tabs and bolts - as the 32 segmented commutators- to secure them to polycarbonate rings....

Regards

Ufopolitics